描述
Arduino NANO IO 多功能擴展板 支援外部電源 方便接線 UNO R3 也適用
台灣智能感測科技官網, 購買 更多關於 arduino, nano, 擴展板, 的產品
Arduino NANO IO 多功能擴展板 支援外部電源 方便接線 UNO R3 也適用
專門為 arduino NANO量身打造，焊上的兩排針腳，即可使用在Arduino duemilanove 2009 、UNO R1。該擴展板,解決了NANO在連接多款傳感器的時候佈線混亂的問題,成為你開發Arduino作品的利器.
- 引出所有的數位IO口和類比IO口,每個IO口都有標配的正負電源接口
- 引出主板上的I2C的接口,方便和I2C的設備的接駁
- 增加DC供電接口.NANO板上的USB接口供電電流實際只有50MA,要帶大電流的設備比如舵機的時候就明顯不足,這個時候在DC供電接口提供外接電源,保證設備運行的穩定。
Arduino Nano I / O Expansion Sensor Shield Module for Arduino UNO R3 Nano
- This IO Expansion Shield is specifically designed to facilitate an easy connection between Arduino Nano and many other devices.
- Used for Arduino Nano direct, if your seal the Pin of the board also Compatible Arduino Duemilanove 2009 and UNO R1.
- 5 I2C expansion Pin. I2C interface on the main board, convenient and connection of the I2C device.
- Compatible with Arduino or Arduino-compatible Nano v3.0
- 14 I/O Pin (servo type with GND, power and signal).
AREF output
3.3V output
8 analog Pin with power output and GND
6 PWM Pin
1 Servo power input
I2C expansion Pin
Draw out all of the digital I/o mouth and analog I/o mouth, every IO mouth has the positive and negative power supply interface standard
Increase the DC power supply interface.
The NANO plate on the USB interface power supply current is actual only 50 ma, to bring high current equipment such as steering gear
Size:60*53*13mm(L*W*H)
